Roland JD-XA - Part Edit

3
Program Parameters
Part Edit
These parameters are common to analog parts and digital parts.
1. Press the [Menu] button.
2. Use the cursor [
K
] [
J
] buttons to select “PART EDIT” and press the [Enter] button.
PART: Kbd Sw parameter appears.
MEMO
Use the ANALOG PART Select [01]–[04] buttons and DIGITAL PART Select [01]–[04] buttons to select the part that you want to edit.
Menu
[Shift] + Cursor [
K
] [
J
]
Parameter
Cursor [
K
] [
J
]
Value
Value [-] [+]
Explanation
PART
(Part)
Kbd Sw
(Keyboard Switch)
OFF, ON
Turns each part’s keyboard switch on/o.
* This parameter is switched when you press the Part On button.
Range Lower
(Keyboard Range Lower)
C -1–G 9 Species the lowest key of the keyboard range for each part.
Range Upper
(Keyboard Range Upper)
C -1–G 9
Species the highest key of the keyboard range for each part.
* If you raise the lowest key above the highest key, or the highest key below the lowest key,
the other setting will change to the same value.
Arp Sw
(Arpeggio Switch)
OFF, ON Turns each part’s arpeggio switch on/o.
Mute Sw
(Mute Switch)
OFF, ON
Species whether each part’s performance is temporarily muted (ON) or not muted (OFF).
* The Mute parameter does not turn the part o; it mutes the sound by minimizing the
volume. Therefore, the part still receives MIDI messages.
Level 0–127
Adjust the volume of each part.
This setting’s main purpose is to adjust the volume balance between parts.
Pan L64–0–63R
Adjust the pan of each part.
“L64” is far left, “0” is center, and “63R” is far right.
Rev Send
(Reverb Send Level)
0–127
Adjusts the amount of reverb for each part.
If you don’t want to add the reverb eect, set it to “0.”
Voc Send Sw
(Vocoder Send Switch)
OFF, ON Species whether each part is sent through the vocoder.
PART MIDI
(Part MIDI)
Ch
(Channel)
1–16 Species the MIDI channel of each part.
Rx Bender
(Receive Bender)
OFF, ON
For each MIDI channel, specify whether MIDI Pitch Bend messages will be received “ON,” or not
“OFF.”
Rx PolyPress
(Receive Polyphonic Key Pressure)
OFF, ON
For each MIDI channel, specify whether MIDI polyphonic key pressure messages will be received
“ON,” or not “OFF.”
Rx Ch Press
(Receive Channel Pressure)
OFF, ON
For each MIDI channel, specify whether MIDI Channel Pressure messages will be received “ON,”
or not “OFF.”
Rx Mod
(Receive Modulation)
OFF, ON
For each MIDI channel, specify whether MIDI Modulation messages will be received “ON,” or
not “OFF.”
Rx Volume
(Receive Volume)
OFF, ON
For each MIDI channel, specify whether MIDI Volume messages will be received “ON,” or not
“OFF.”
Rx Pan
(Receive Pan)
OFF, ON For each MIDI channel, specify whether MIDI Pan messages will be received “ON,” or not “OFF.”
Rx Express
(Receive Expression)
OFF, ON
For each MIDI channel, specify whether MIDI Expression messages will be received “ON,” or not
“OFF.”
Rx Hold-1
(Receive Hold-1)
OFF, ON
For each MIDI channel, specify whether MIDI Hold 1 messages will be received “ON,” or not
“OFF.”