Roland JD-XA - Cho->Flg (Chorus 0 Flanger); Flg->Dly (Flanger 0 Delay)

53
Eects
66: Flg->Dly
(Flanger 0 Delay)
Feedback
Delay
L in
R in
L out
R out
Balance W
Balance W
Balance D
Balance D
Flanger
Balance W
Balance W
Balance D
Balance D
Feedback
Parameter Value Explanation
Flg PreDly
(Flanger Pre Delay)
0.0–100.0 ms
Adjusts the delay time from the
direct sound until the anger sound
is heard.
Flg Sync
(Flanger Sync)
Hz, NOTE
Hz: The Flg Rate value is specied
in Hz.
NOTE: The Flg Rate value is specied
as a note value.
Flg Rate #
(Flanger Rate)
0.05–10.00 Hz,
note
Rate of modulation
Flg Depth
(Flanger Depth)
0–127 Depth of modulation
FlgFeedback #
(Flanger Feedback)
-98–+98%
Adjusts the proportion of the anger
sound that is fed back into the
eect.
Negative (-) values invert the phase.
Flg Bal #
(Flanger Balance)
D100:0W–
D0:100W
Volume balance between the direct
sound (D) and the anger sound (W)
Delay Sync msec, NOTE
msec: The Dly Time/Note value is
specied in msec.
NOTE: The Dly Time/Note value is
specied as a note value.
Dly Time/Note
(Delay Time/Note)
0–2600 ms, note
Adjusts the delay time from the
direct sound until the delay sound
is heard.
DlyFeedback #
(Delay Feedback)
-98–+98%
Adjusts the proportion of the delay
sound that is fed back into the
eect.
Negative (-) values invert the phase.
D HF Damp
(Delay HF Damp)
200–8000 Hz,
BYPASS
Adjusts the frequency above which
sound fed back to the eect will be
cut. If you do not want to cut the
high frequencies, set this parameter
to BYPASS.
Dly Bal #
(Delay Balance)
D100:0W–
D0:100W
Adjusts the volume balance
between the sound that is sent
through the delay (W) and the
sound that is not sent through the
delay (D).
Level 0–127 Output volume
67: Cho->Flg
(Chorus 0 Flanger)
Feedback
Flanger
L in
R in
L out
R out
Balance W
Balance W
Balance D
Balance D
Chorus
Balance W
Balance W
Balance D
Balance D
Parameter Value Explanation
Cho PreDly
(Chorus Pre Delay)
0.0–100.0 ms
Adjusts the delay time from the
direct sound until the chorus sound
is heard.
ChorusSync Hz, NOTE
Hz: The Cho Rate value is specied
in Hz.
NOTE: The Cho Rate value is
specied as a note value.
Parameter Value Explanation
Cho Rate #
(Chorus Rate)
0.05–10.00 Hz,
note
Modulation frequency of the chorus
eect
Chorus Depth 0–127
Modulation depth of the chorus
eect
Cho Bal #
(Chorus Balance)
D100:0W–
D0:100W
Volume balance between the direct
sound (D) and the chorus sound (W)
Flg PreDly
(Flanger Pre Delay)
0.0–100.0 ms
Adjusts the delay time from the
direct sound until the anger sound
is heard.
Flg Sync
(Flanger Sync)
Hz, NOTE
Hz: The Flg Rate value is specied
in Hz.
NOTE: The Flg Rate value is specied
as a note value.
Flg Rate #
(Flanger Rate)
0.05–10.00 Hz,
note
Modulation frequency of the anger
eect
Flg Depth
(Flanger Depth)
0–127
Modulation depth of the anger
eect
FlgFeedback #
(Flanger Feedback)
-98–+98%
Adjusts the proportion of the anger
sound that is fed back into the
eect.
Negative (-) values invert the phase.
Flg Bal #
(Flanger Balance)
D100:0W–
D0:100W
Adjusts the volume balance
between the sound that is sent
through the anger (W) and the
sound that is not sent through the
anger (D).
Level 0–127 Output volume
Note
Sixty-fourth-note
triplet
Sixty-fourth note
Thirty-second-note
triplet
Thirty-second note
Sixteenth-note
triplet
Dotted thirty-
second note
Sixteenth note Eighth-note triplet
Dotted sixteenth
note
Eighth note Quarter-note triplet Dotted eighth note
Quarter note Half-note triplet Dotted quarter note Half note
Whole-note triplet Dotted half note Whole note Double-note triplet
Dotted whole note Double note