Roland JD-XA - 05: Enhancer (Enhancer); 06: Auto Wah (Auto Wah); 07: Humanizer (Humanizer); 08: Sp Sim (Speaker Simulator)

27
Eects
05: Enhancer
(Enhancer)
Controls the overtone structure of the high frequencies, adding
sparkle and tightness to the sound.
L in
R in
L out
R out
Mix
Mix
Enhancer
Enhancer
2-Band
EQ
2-Band
EQ
Parameter Value Explanation
Sens # 0–127 Sensitivity of the enhancer
Mix # 0–127
Level of the overtones generated by
the enhancer
Low Gain -15–+15 dB Amount of low-range boost/cut
High Gain -15–+15 dB Amount of high-range boost/cut
Level 0–127 Output volume
06: Auto Wah
(Auto Wah)
Cyclically controls a lter to create cyclic change in timbre.
L in
R in
L out
R out
Auto Wah
2-Band EQ
2-Band EQ
Auto Wah
Parameter Value Explanation
Filter Type LPF, BPF
Type of lter
LPF: Produces a wah eect in a
broad frequency range.
BPF: Produces a wah eect in a
narrow frequency range.
Manual # 0–127
Center frequency at which the wah
eect is applied
Peak 0–127
Width of the frequency region at
which the wah eect is applied
Increasing this value will make the
frequency region narrower.
Sens # 0–127
Sensitivity with which the lter is
modied
Polarity UP, DOWN
Sets the direction in which the
frequency will change when the
auto-wah lter is modulated.
UP: The lter will change toward a
higher frequency.
DOWN: The lter will change toward
a lower frequency.
Sync Hz, NOTE
Hz: The Rate value is specied in Hz.
NOTE: The Rate value is specied as
a note value.
Rate #
0.05–10.00 Hz,
note
Rate at which the wah eect is
modulated
Depth # 0–127
Depth at which the wah eect is
modulated
Phase # 0–180 deg
Adjusts the degree of phase shift of
the left and right sounds when the
wah eect is applied.
Low Gain -15–+15 dB Amount of low-range boost/cut
High Gain -15–+15 dB Amount of high-range boost/cut
Level 0–127 Output volume
07: Humanizer
(Humanizer)
Adds a vowel character to the sound, making it similar to a human
voice.
Formant
2-Band
EQ
L in
R in
Overdrive
L out
R out
Pan R
Pan L
Parameter Value Explanation
Drive Sw OFF, ON Overdrive on/o
Drive # 0–127
Degree of distortion
Also changes the volume.
Vowel1 a, e, i, o, u Vowel1
Vowel2 a, e, i, o, u Vowel2
Sync Hz, NOTE
Hz: The Rate value is specied in Hz.
NOTE: The Rate value is specied as
a note value.
Rate #
0.05–10.00 Hz,
note
Frequency at which the two vowels
switch
Depth # 0–127 Depth of the eect
In Sync Sw
(Input Sync Switch)
OFF, ON
LFO reset on/o
Determines whether the LFO for
switching the vowels is reset by the
input signal (ON) or not (OFF).
In Sync Thre
(Input Sync
Threshold)
0–127
Volume level at which reset is
applied
Manual # 0–100
Point at which Vowel 1/2 switch
49 or less: Vowel 1 will have a
longer duration.
50: Vowel 1 and 2 will be of equal
duration.
51 or more: Vowel 2 will have a
longer duration.
Low Gain -15–+15 dB Amount of low-range boost/cut
High Gain -15–+15 dB Amount of high-range boost/cut
Pan # L64–63R Stereo location of the output
Level 0–127 Output volume
08: Sp Sim
(Speaker Simulator)
Simulates the speaker type and microphone settings used to record
the speaker sound.
L in
R in
L out
R out
Speaker
Speaker
Parameter Value Explanation
Type
(See the following table)
Type of speaker
Mic Setting 1, 2, 3
Adjusts the location of the
microphone that is recording the
sound of the speaker.
This can be adjusted in three steps,
from 1 to 3, with the microphone
becoming more distant as the value
increases.
Mic Level # 0–127 Volume of the microphone
Direct Level # 0–127 Volume of the direct sound
Level # 0–127 Output volume