Roland JD-XA - EP->Flg (EP Amp Sim 0 Flanger); EP->Ph (EP Amp Sim 0 Phaser)

50
Eects
59: EP->Flg
(EP Amp Sim 0 Flanger)
L in
R in
L out
R out
SpeakerEP Amp
Balance W
Balance W
Balance D
Balance D
Feedback
Flanger
Parameter Value Explanation
Type
OLDCASE,
NEWCASE,
WURLY
Type of amp
OLDCASE: a standard electric piano
sound of the early 70s
NEWCASE: a standard electric piano
sound of the late 70s and early 80s
WURLY: a standard electric piano
sound of the 60s
Bass # -50–+50 Amount of low-frequency boost/cut
Treble # -50–+50
Amount of high-frequency boost/
cut
Flanger Sw #
(Flanger Switch)
OFF, ON Flanger on/o
Flg PreDly
(Flanger Pre Delay)
0.0–100.0 ms
Adjusts the delay time from the
direct sound until the anger sound
is heard.
Flg Sync
(Flanger Sync)
Hz, NOTE
Hz: The Flg Rate value is specied
in Hz.
NOTE: The Flg Rate value is specied
as a note value.
Flg Rate #
(Flanger Rate)
0.05–10.00 Hz,
note
Rate of modulation
Flg Depth #
(Flanger Depth)
0–127 Depth of modulation
FlgFeedback #
(Flanger Feedback)
-98–+98%
Adjusts the proportion of the anger
sound that is fed back into the
eect.
Negative (-) values invert the phase.
Flg Bal #
(Flanger Balance)
D100:0W–
D0:100W
Adjusts the volume balance
between the sound that is sent
through the anger (W) and the
sound that is not sent through the
anger (D).
Sp Type
(Speaker Type)
LINE, OLD, NEW,
WURLY, TWIN
Type of speaker
* If LINE is selected, the sound will
not be sent through the speaker
simulation.
OD Switch
(Overdrive Switch)
OFF, ON Overdrive on/o
OD Gain
(Overdrive Gain)
0–127 Overdrive input level
OD Drive
(Overdrive Drive)
0–127 Degree of distortion
Level 0–127 Output volume
60: EP->Ph
(EP Amp Sim 0 Phaser)
L in
R in
L out
R out
EP
Amp
Speaker
Phaser
Resonance
Mix
Parameter Value Explanation
Type
OLDCASE,
NEWCASE,
WURLY
Type of amp
OLDCASE: a standard electric piano
sound of the early 70s
NEWCASE: a standard electric piano
sound of the late 70s and early 80s
WURLY: a standard electric piano
sound of the 60s
Bass # -50–+50 Amount of low-frequency boost/cut
Treble # -50–+50
Amount of high-frequency boost/
cut
Phaser Sw #
(Phaser Switch)
OFF, ON Phaser on/o
Phs Sync
(Phaser Sync)
Hz, NOTE
Hz: The Phs Rate value is specied
in Hz.
NOTE: The Phs Rate value is
specied as a note value.
Phs Rate #
(Phaser Rate)
0.05–10.00 Hz,
note
Modulation rate
Phs Manual #
(Phaser Manual)
0–127
Center frequency at which the
sound is modulated
Phs Depth #
(Phaser Depth)
0–127 Modulation depth
Phs Reso #
(Phaser Resonance)
0–127 Amount of feedback
Phs Mix #
(Phaser Mix)
0–127 Volume of phase-shifted sound
Sp Type
(Speaker Type)
LINE, OLD, NEW,
WURLY, TWIN
Type of speaker
* If LINE is selected, the sound will
not be sent through the speaker
simulation.
OD Switch
(Overdrive Switch)
OFF, ON Overdrive on/o
OD Gain
(Overdrive Gain)
0–127 Overdrive input level
OD Drive
(Overdrive Drive)
0–127 Degree of distortion
Level 0–127 Output volume