Press and hold .
Hold down until the print-end position reaches the platen.
For media that passes through the media discharge port of ①, be sure to comply with the
following. Otherwise problems such as the print heads striking the sheet media may occur,
resulting in malfunction or the like.
Never use the media clamps.
Increase the height of the print heads.
P. 106, "Adjusting Head Height to Match Media Thickness"
Press and hold .
Hold down until the end of the sheet media reaches the location shown in the gure.
3.
Get ready to receive the data from the computer.
Close the front cover.
Use to select "PIECE."
Press
.
To Next Page
Loading...
Need help?
General