How to Load Sheet Media
To load and use sheet media, follow the steps below.
1.
Load the sheet media.
Measure the thickness of the sheet media.
If the measured value is 0.5 millimeters or more, increase the height of the print heads.
P. 106, "Adjusting Head Height to Match Media Thickness"
Detach the rear cover.
If roll media is loaded, then remove it.
Remove both shafts.
Pass the sheet media through the machine.
Attach the rear cover.
Rear cover
Engage.
Rear cover
Engage.
To Next Page
Loading...
Need help?
General