106
Chapter 5 Feature Reference Chapter 5 Feature Reference
5-5
Optimizing Printing to Match Media Thickness
Adjusting Head Height to Match Media Thickness
Procedure
Press .
Press
several times.
Press .
Open the front cover.
Move the lever to adjust the height of the head.
Moving the lever to "HIGH" makes a warning beep sound twice. Moving it to "LOW" makes the
warning beep sound once.
Close the front cover.
The print heads return to their original position and the screen
shown in the gure appears.
Press .
Press
to go back to the original screen.
Description
Depending on the media, the media may be thick, or may wrinkle or come loose from the platen dur-
ing printing, increasing the chance of contact with the print heads. When you're using such media, set
[HEAD HEIGHT] to "HIGH."
Printing quality when [HEAD HEIGHT] is set to "HIGH" may be coarser or otherwise lower than when
set to "LOW." If this happens, refer to the pages indicated below.
P. 95, "Preventing Soiling of the Media and Dot Drop-out During Printing," p. 107, "Correcting for Misalignment
Height-adjustment lever
Move rmly, until it stops.
HIGH
LOW
Height-adjustment lever
Move rmly, until it stops.
HIGH
LOW
To Next Page
Loading...
Need help?
General