Description
Hardened ink is thick. This means that the cutting conditions when you're cutting a printed surface
are dierent from the cutting conditions when you're cutting a surface that hasn't been printed. When
you're cutting a printed surface, use this [CUT TEST PRINT] to adjust the cutting conditions.
Note: These adjustments are general suggestions. Their accuracy is not assured.
Preventing Pulling of the Media with Undue Force When Performing Cutting Only
Procedure
Press .
Press
several times.
Press .
Press
several times.
Press .
Use
to select "ENABLE."
Press
to enable the setting.
Press .
Press
to go back to the original screen.
Description
When you're performing cutting only, it may be convenient to set this feature to "ENABLE." This feeds
out media according to the size of the data sent from the computer before performing cutting. This
makes it unnecessary to turn the media anges by hand to feed out media every time you perform
cutting. Note, however, that this feeds out media even when you're performing printing only, so set it
to "DISABLE" when not needed.
To Next Page
Loading...
Need help?
General