EasyManuals Logo

Roland LEC-300A User Manual

Roland LEC-300A
180 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #46 background imageLoading...
Page #46 background image
44
Chapter 2 Basic Operation Chapter 2 Basic Operation
2-4 Starting Printing
Getting Ready to Receive Data from a Computer
When you have nished loading media, then follow the steps below. This procedure enables the machine
to receive data from the computer and perform output. When printing data that includes cutting paths is
received, you can also carry out cutting immediately after performing printing. Note, however, that when
you want to perform only cutting, operation that diers from the following procedure is required.
P. 51, "To Perform Cutting"
Procedure
Close the front cover.
Make sure stays steadily lit.
Make sure you are at the top menu.
If you are not at the top menu, press then press .
Printing Is Not Possible in These Situations
The machine does not run when the front cover is open. Also, never open it when printing is in
progress. Doing so interrupts printing.
Data from the computer is not accepted when
is dark.
Data from the computer is not accepted when you are not at the top menu.
Points Which Must Be Observed
Be sure to set the media clamps during printing. Otherwise the edges of the media may warp and
catch on the print heads.
During printing, never touch the media that's already been discharged. Doing so may obstruct media
feed or cause the media to rub against the heads, which may result in a paper jam or damage to the
heads.
Top screen
Steadily lighted

Table of Contents

Other manuals for Roland LEC-300A

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Roland LEC-300A and is the answer not in the manual?

Roland LEC-300A Specifications

General IconGeneral
BrandRoland
ModelLEC-300A
CategoryPrinter
LanguageEnglish

Related product manuals