Description
The movement distance of media experiences subtle changes due to the thickness of the media . When
the movement distance becomes discrepant, horizontal stripes are more likely to occur during print-
ing. We recommend performing correction to match the media you're using. Also, perform the actual
printing in an operating environment identical to that used for the test pattern.
To make the setting for the correction value even more accurate, we recommend carrying out the fol-
lowing before printing the test pattern.
After loading the media, use
to feed out the media by about one meter.
Set the print-start position near the center of the media.
P. 91, "Setting the Print-start Position"
Note, however, that you can also make this setting on the computer (by, for example, choosing the
media type in the software RIP you are using). When you have made the setting on the computer, the
computer's setting is used and the printer's setting is ignored.
Default Setting
[SETTING]: 0.00%
Approx. 1 mPrint-start position
To Next Page
Loading...
Need help?
General