Rotax 914 series Maintenance Manual

BRP-Rotax
Maintenance Manual
72-00-00
page 64
May 01/2007
Effectivity 912/914 Series
Edition 1 / Rev. 0
d02622
3.11.5) Valves
See Figs. 72-67, 72-68, 72-69 and 72-70.
Intake valves are checked as follows:
Carry out a visual inspection of the valves for damage and wear.
Clean valves, measure valve stem diameter and check valve disk for
wear.
The valve stem diameter VT01 is measured at the edge of the moving
path (1) of the valve stem. See Fig. 72-67.
See 72-00-00 sec. 4.
Check valve front surface (5) for pitting.
Check valve stem for possible deposits. Heavy oil carbon residues (2)
on the valve stem indicate increased wear on the valve guide.
3 mm
max 20%
3 mm
VT01
VT01
3
1
2
5
07443
Fig. 72-67
(0.12 in.)
(0.12 in.)

Rotax 914 series Specifications

General

Bore	79.5 mm
Stroke	61 mm
Compression Ratio	9.0:1
Cooling System	Liquid-cooled cylinder heads, air-cooled cylinders
Redline	5800 rpm
Engine Type	4-cylinder, 4-stroke
Fuel Type	Avgas 100LL
Oil System	Dry sump
Fuel System	fuel injection
TBO (Time Between Overhauls)	2000 hours
Displacement	1.211 liters (1211 cc)
Power Output	84.6 kW (115 hp) at 5, 800 rpm