EasyManuals Logo

Rotax 914 series Maintenance Manual

Rotax 914 series
456 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #235 background imageLoading...
Page #235 background image
Effectivity 914 Series
Edition 1 / Rev. 0
page 49
May 01/2007
d02623
73-00-00
BRP-Rotax
Maintenance Manual
3.4.9) Pressure connecting lines (only on 914 Series)
See Figs. 73-42 and 73-43.
The pressure connecting lines are of essential importance for safe
operation of the engine.
See also 73-00-00 sec. 2 and the correspond-
ing Maintenance Manual (Line Maintenance) for the respective engine
type, 912 or 914 Series.
Check all lines and T-fittings for damage (mechanical, thermal, etc.)
and leakage.
â–  CAUTION: All lines are secured with clamps. Check them for
security.
If the lines have been detached or replaced, connect them correctly:
- hose nipple (2) to the T-fitting (3)
- T-fitting (3) to the fuel pressure regulator (4)
- T-fitting (3) to the condensation trap (5) (on older engine configura-
tions)
- condensation trap (5) to the airbox pressure sensor (on older engine
configurations)
- hose nipple (6) to solenoid valve (7) ( (towards 2-pin electric
connector (8))
- hose nipple (9) to solenoid valve (7) ( (towards electric connector (8)
on the opposite side)
- solenoid valve (7) (top connection) to T-fitting (10)
- T-fitting (10) to float chamber venting of carburetor 1/3
- T-fitting (10) to float chamber venting of carburetor 2/4
Secure all lines with clamps 8 (11).
An exception are the 3 lines on the solenoid valve which, due to the
shape of the valve, must be secured with clamps 6.8 (12).
The lines to the float chamber venting must be fixed to the fuel lines with
tie wraps (13) . Do not constrict!

Table of Contents

Other manuals for Rotax 914 series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Rotax 914 series and is the answer not in the manual?

Rotax 914 series Specifications

General IconGeneral
Bore79.5 mm
Stroke61 mm
Compression Ratio9.0:1
Cooling SystemLiquid-cooled cylinder heads, air-cooled cylinders
Redline5800 rpm
Engine Type4-cylinder, 4-stroke
Fuel TypeAvgas 100LL
Oil SystemDry sump
Fuel Systemfuel injection
TBO (Time Between Overhauls)2000 hours
Displacement1.211 liters (1211 cc)
Power Output84.6 kW (115 hp) at 5, 800 rpm

Related product manuals