rotork IQ Range - Assets - Actuator

A4US
US
A4
US A4
US
A4
A4 US
US
A4
US
A4
A4 US
IQ3 Full Configuration Manual – Section: Assets 61
5.1 Assets – Actuator
Open Limit
Actuator
Actuator NamePlate
Actuator Std Build
Actuator Opt Build
Stopped
Actuator NamePlate
Tag (-
o
-) [-O-] (-
o
-)
Serial No Dans Demo
Size IQS12
Base F10
Coupling A
Wiring Diag 123B0000
Speed 24.0
1/11
Actuator Name Plate Information
This screen displays the nameplate information of the actuator.
Should the physical nameplate become damaged or lost,
the information for the actuator will remain accessible. The
information shown is read only with the exception of the
actuator Tag which can be edited by the user after entering a
valid password.
To change, press to select the highlighted field.
Use and to scroll through alphabetic and numerical
figures to display the required character.
Use
to move to the next character.
Use to delete the previous character.
Use to save the information.
1/11 Tag
The tag entry in Actuator Nameplate will be shown on the
actuators set home screen display. The tag name entered should
be the valve and/or actuator reference that identifies the asset
within the site process control scheme. If the tag was supplied at
time of order, Rotork will populate the entry automatically.
The user may edit the tag after a valid password has been
entered.
2/11 Serial No
Displays the actuator serial number. This should always be
quoted when making any enquiry to Rotork or our agents.
3/11 Size
Displays the actuator model and size, for example "IQ25" or
"IQT125".
4/11 Base
Displays the actuator base size according to standard ISO 5210
/ 5211 for metric bases and MSS SP-101 / SP-102 for imperial
bases, for example "F14".
5/11 Coupling
Displays the actuator drive coupling type and designation
according to standard ISO5210 / 5211. The drive couplings
available are A, Z3*, B1, B3, B4 (B only for IQT).
*Z3 coupling is an extended length version of an "A" coupling but with
the same stem acceptance dimension. It is a Rotork standard and is not
referenced in standard ISO5210.
5.1.1 Actuator – Actuator Nameplate