Roundshot VR Drive - Working with Presets

23/05/2019Roundshot VR Drive Instruction Manual – Firmware Version 2.023 135
6.9 Working with presets
Click on “presets” to define the parameter preferences of your VR
Drive.
The “presets” are grouped by software mode:
• “quality”
• “speed”
• “turntable”
• “video”
• “HDR”
• “timelapse”
Click on “quality”, “speed”, “turntable”, “video” or “HDR” to set
up the presets.
Click on the preset to
modify, for example the
A-value:
The VR Drive has a default value (preset) for every parameter of every mode. When
creating a new program these values are always suggested by default, and needs to be
adapted each time to the hardware setting currently used.
This behaviour can be optimised by changing these preset values and make them match
with the camera, lens and software parameters most often used.
For example, when always using the same camera, it is more efficient to set the
corresponding A-value to a preset. This way, this value will always be automatically loaded
every time a new program is created.
presets
presets
turntable
video
HDR
speedquality
presets
quality
info
Nikon
D3
focal lenght
24 mm
A/B value
0/ 0mm
angle mode
cylindrical
Edit P1 / page 1
A
mm
[1..999]
B
mm
[1..999]
35
0
info
Nikon D3
focal length
24mm
A/B value
1/1 mm
angle mode
cylindrical
Mode
quality
X
360°
Y
88°
timelapse
By setting presets the regular program creation will be optimized without reducing
the VR Drive flexibility. Even if the default value will corresponds to your most used
setup, it is still possible to edit all parameters either during new program creation
with the wizard or in the edit menu .