RTK 725 Series User Manual

RTK Series 725 Annunciator
14
3.13 Automatic Mute Or Automatic Acknowledge
Each annunciator is equipped with an integral timer that can be enabled to allow the user to
automatically mute or acknowledge alarms after a pre-set time delay. To set the automatic mute or
acknowledge feature the pushbutton / programming module must be hinged down by inserting a
small flat blade screw driver into the recess on the upper face of the associated surround bezel and
gently levering the pushbutton assembly forward to reveal the information plate which is visible on
the inside face of the module. The two pozidrive screws and washers in the centre of the plate should
be removed to allow access to DIL switch SW7, which is used to set the unit to automatically silence
or acknowledge and to set the required time delay.
Auto Mute / Ack Delay Switch Location (Information Plate Removed)
A4219-*
Posidrive
screws
CB4072POP
ON
SW7
ON OFF
1
OFF
3
2
4
SW7
Automatic Acknowledge or Silence Time Selection
FUNCTION SW7-1 SW7-2 SW7-3 SW7-4
Automatic acknowledge ON
UNUSED
Automatic mute OFF
Disable automatic timer OFF OFF
Enable 1 minute time delay ON OFF
Enable 4 minute time delay OFF ON
Enable 8 minute time delay ON ON

RTK 725 Series Specifications

General

Brand	RTK
Model	725 Series
Category	Security System
Language	English