7
Introducing the ZoneFlex Access Point
Getting to Know the Access Point Features
Tabl e 5 lists all possible LED states on ZoneFlex 2942/7942 and describes what each
LED state means. It also describes how to use the HARD RESET button and other
elements on the side panel.
Table 5. ZoneFlex 2942/7942 side panel elements
Number LED/Button Name Description
1 OPT LED Not used in this model
2 DIR LED • Off: The Access Point is not being managed by
ZoneDirector (standalone mode).
• Green: The Access Point is being managed by
ZoneDirector.
• Flashing green: The Access Point is being
managed by ZoneDirector, but is currently unable
to communicate with ZoneDirector.
3 AIR LED • Green: The Access Point is functioning as a mesh
AP (MAP) and the wireless signal to its uplink MAP
is good (> 24dbm).
• Fast flashing green (two flashes every second):
The Access Point is functioning as a mesh AP
(MAP) and the wireless signal to its uplink MAP is
poor (< 24dbm).
• Slow flashing green (one flash every two seconds):
Mesh networking is enabled, but the Access Point
cannot find a mesh uplink.
• Off: The Access Point is operating in standalone
mode or, if mesh networking is enabled, the
Access Point is functioning as a root AP (RAP).
To Next Page