71
Managing the Access Point
Enabling Other Management Access Options
Figure 36. The Administration > Management page
To enable other management access options
1. Go to Administration > Management. The Management page appears.
2. Review the access options listed in Table 2 1
, and then make changes as needed.
Table 21. Management Access Options
Option Description
Telnet access By default, this option is disabled (inactive).
Telnet port This field lists the default Telnet port of 23 — only
if Telnet is active. You can manually change this
port number, if required.
SSH access By default, this option is enabled (active).
SSH port This field lists the default SSH port of 22—only if
SSH is active. You can manually change this port
number if required.
HTTP access This option is disabled by default.
HTTP port This field lists the default HTTP port of 80, if HTTP
has been activated. You can manually change this
port number if required.
HTTPS access By default this option is enabled. This connection
mode requires a security certificate, a copy of
which has been pre-installed in the device.
To Next Page
Loading...
