Ruida Technology RDC6432G - Feeding Parameters; Memory Operation

RDC6432G control system user manual V1.1
SHENZHEN RUIDA TECHNOLOGY
50
7. After the parameters are set, select [Write Parameters], and press [Enter] to save the parameter
settings.
8.6.3 Feeding parameters
In the above interface, select the "Feeding Parameters" item and press [Enter] key, then the pop-up menu
is shown as below:
Figure 8.6.3
1. Press the arrow keys to select [Read Parameters], and press the [Enter].
2. Press the arrow keys to move the red box, press [Enter] to confirm the setting of the current red box
parameters, press the key to increase the value of the underline, and press the key to reduce the
value of the underline.
3. After the modification is completed, press [Enter] to save the current parameter settings.
4. After the parameters are set, select [Write Parameters], and press [Enter] to save the parameter
settings.
8.6.4 Memory operation
Select the "Memery oper" item in the interface above, and the pop-up menu is as shown below:
Figure 8.6.4