Web-based Configuration Guide System Management
2109
10.9.4 Packet Capture
Choose Local Device > Diagnostics > Packet Capture.
If the device fails and troubleshooting is required, the packet capture result can be analyzed to locate and rectify
the fault.
Select an interface and a protocol and specify the host IP address to capture the content in data packets. Select
the file size limit and packet count limit to determine the conditions for automatically stopping packet capture. (If
the file size or number of packets reaches the specified threshold, packet capture stops and a diagnostic package
download link is generated.) Click Start to execute the packet capture command.
Caution
The packet capture operation may occupy many system resources, causing network freezing. Therefore,
exercise caution when performing this operation.
To Next Page
Loading...
Need help?
General
