Web-based Configuration Guide 1 Login
6
If a new device is detected not in the network, click Add to My Network and enter its management password to
add the device manually.
Note
If there is a firewall device in the network, the Firewall Port Config page appears. Select the corresponding
port for configuration.
2. Creating a Network Project
Click Start Setup to configure the Internet connection type and management password.
(1) Network Name: Identify the network where the device is located.
(2) Internet: Configure the Internet connection type according to the requirements of the local ISP.
○ DHCP: The router detects whether it can obtain an IP address via DHCP by default. If the router connects
to the Internet successfully, you can click Next without entering an account.
○ PPPoE: Click PPPoE, and enter the username, password, and service name. Click Next.
○ Static IP: Enter the IP address, subnet mask, gateway, and DNS server, and click Next.
(3) Management Password: The password is used for logging in to the management page.
(4) Country/Region: You are advised to select the actual country or region.
(5) Time Zone: Set the system time. The network time server is enabled by default to provide the time service.
You are advised to select the actual time zone.
To Next Page
Loading...
