Web-based Configuration Guide 1 Login
4
management client can access the device. For example, set the IP address of the management client to
192.168.110.200.
1.3.3 Login
Enter the IP address (192.168.110.1 by default) of the router in the address bar of the browser to open the login
page.
Note
If the static IP address of the device is changed, or the device obtains a new dynamic IP address, the new IP
address can be used to access the web management system of the device as long as the management client
and the device are in the same network segment of a LAN.
(1) On the web page, enter the password and click Log In to enter the web management system.
Username and password are not required at your first login and you can configure the router directly.
For device security, you are advised to set the management password after your first login to the web
management system. After the password is set, you need to enter the password when you log in to the web
management system again.
If you forget the IP address or password, hold down the Reset button on the device panel for more than 5
seconds when the device is connected to the power supply to restore factory settings. After restoration, you
can use the default IP address and password to log in.
Caution
Restoring factory settings will delete the existing configuration and you are required to configure the device
again at your next login. Therefore, exercise caution when performing this operation.
To Next Page
Loading...
Need help?
General
