Web-based Configuration Guide 1 Network Settings
58
Table 3-8 Static route configuration
Specify the destination network to which the data packet is to be sent. The device
matches the data packet based on the destination address and subnet mask.
Specify the subnet mask of the destination network. The device matches the data
packet based on the destination address and subnet mask.
Specify the interface that forwards the data packet.
Specify the IP address of the next hop in the route for the data packet. If the
outbound interface accesses the Internet through PPPoE dialing, you do not need
to configure the next-hop address.
After a static route is created, you can find the relevant route configuration and reachability status in the static
route list. The Reachable parameter specifies whether the next hop is reachable, based on which you can
determine whether the route takes effect. If the value is No, check whether the outbound interface in the current
route can ping the next-hop address.
To Next Page
Loading...
Need help?
General
