Serial Communications Page 7-
________________________________________________________________
_ Operating the Model 2010D Remotely using Terminal Mode
Once the Model 2010D and all modems, computers and cables are
configured correctly, it is simple matter to establish a
communications link and operate the Model 2010D remotely. The
Model 2010D can sense that a communications link is active by
monitoring the DSR line. When a connection is sensed (e.g. when
the modem answers the phone or a cable is attached), the Model
2010D will present the following log-in message:
Sabio Model 2010D Dilution Calibrator Remote Access
Press any key to continue ...
Simply pressing a key will log into the Model 2010D and an exact
image of the Model 2010D's front panel display will be presented
on the remote computer's screen. Subsequently pressing keys,
either on the front panel or at the remote computer, will cause
both screens to respond accordingly.
If command mode is enabled and a command is sent, the 2010D
automatically switches to command mode. Pressing the ESC key
will return the 2010D to terminal mode.
Most keys on the remote computer's keyboard correspond to
equivalent keys on the Model 2010D's front panel, however there
are a few exceptions, which are listed below.
Table 7-1 PC Keyboard Model 2010D Key Mapping
PC
Keyboard Function
Model
2010D
Front
Panel
___________
_________ _________________________
F2 Shift-TAB Go to the previous field.
F3 TAB Go to the next field.
F4 PgUp Go to the previous page.
F5 PgDn Go to the next page.
F6 ALT-V Toggle voltage/eng. units.
F7 ALT-U Change units.
Standby Home Go to the top menu bar.
Status F8 Display the status screen.
To Next Page
Loading...