Sabio 2010D - Assigning Point Start Patterns

Model 2010D Calibration Setup Page 6-
29
[8] When finished, press the End Sequence button. You will be
prompted to save the information or not. The cursor will be
on the "Y" for saving. Press the Enter button and the
initialization will be saved. If you wish to discard the new
initialization, arrow to the "N" and press the Enter button.
Assigning Point Start Patterns
Any points in any of the 20 possible sequences may be activated by
means of the User Digital I/O Bits when the Model 2010D is
configured for Remote Point Activation.
To set-up the Model 2010D for Remote Point Activation, perform
the following steps:
[1] Configure calibration sequences as described in the section
titled "