Sabio 2010D - Air Source Activation Port; Audit Port Connections

Installation Page 4-
18
Table 4-9 Audit Port Connections
SIGNAL SIGNATURE 2010D J7
__________ _________________
J7-1 CHASSIS GROUND
J7-14 CHASSIS GROUND
J7-2 DAS 1 OUTPUT
J7-15 ANALOG GROUND
J7-3 DAS 2 OUTPUT
J7-16 ANALOG GROUND
J7-4 DAS 3 OUTPUT
J7-17 ANALOG GROUND
J7-5 DAS 4 OUTPUT
J7-18 ANALOG GROUND
J7-6 AIN 1 INPUT +
J7-19 AIN 1 INPUT -
J7-7 AIN 2 INPUT +
J7-20 AIN 2 INPUT -
J7-8 AIN 3 INPUT +
J7-21 AIN 3 INPUT -
J7-9 AIN 4 INPUT +
J7-22 AIN 4 INPUT -
J7-10 ANALOG GROUND
J7-23 ANALOG GROUND
Air Source Activation Port
A standard, off-the-shelf, serial data cable with all pins wired
one to one on both ends will work for connections between the
Model 2010D and the Sabio Engineering Model 1001 Compressed Air
Source. A custom cable may need to be fabricated for other
Compressed Air Sources. The cable for activating a Model 1001
should be equipped with a 9 pin male D connector for the Model
2010D end and a 9 pin female D connector for the Model 1001 end.