Sabio 2010D - Assigning Sequence Start Patterns

Model 2010D Calibration Setup Page 6-
27
[9] When all of the I/O bits have been identified, press the
End Sequence button. You will be prompted to save the
information or not. The cursor will be on the "Y" for
saving. Press the Enter button and the initialization will
be saved. If you wish to discard the new initialization,
arrow to the "N" and press the Enter button.
Assigning Sequence Start Patterns
Any of the 20 possible sequences may be activated when the Model
2010D is configured for Remote Sequence Activation.
To set-up the Model 2010D for Remote Activation
Calibration, perform the following steps:
[1] Configure calibration sequences as described in the section
titled "