Sabio 2010D - Timed Sequence (TS)

Serial Communications Page 7-
22
_________________________________________________________________
Timed Sequence (TS)
This command causes a timed sequence to be initiated. The
sequence to be started is identified by the {seq name} field,
which is the ASCII sequence name.
The point at which to start the sequence can optionally be
entered in the {point} field. If no point is entered, the
sequence will start at the first or last point, depending upon
whether the sequence order is ascending or descending.
A more detailed description of the usage of the {seq name} and
{point} fields can be found on page 25.
Command Format
Command
@ TS , {AAA} , {seq name} , {point} , [CHK] <CR>
Where:
{seq name} = The name of the sequence.
{point} = The starting point. If blank, the sequence starts at the
beginning.
Response
Good: <ACK>
Error: <NAK>[ER][<CR>]
Comments:
Leaving the {seq name} and/or {point} blank will have the
following results:
@ TS , {AAA} , {seq name} , [CHK]<CR>
If a sequence is already active with the same name as {seq
name}, the sequence will be re-started beginning with the
first point (or last point if the sequence order is
descending). If no sequence is active or the sequence is
different, the new sequence will be started, beginning with
the first (or last) point.
@ TS , {AAA} , ,{point} , [CHK]<CR>
If a sequence is already active, the new point in the same
sequence will be activated and the timed sequence will