System Operations Page 3-
Sequences The Sequences menu item invokes screens
for defining, editing, viewing, deleting,
running and aborting calibration
sequences.
Gases The Gases menu item invokes screens to
define gas table items, gas standards and
assign gas standards to ports. Screens
are provided for defining, editing,
viewing, and deleting these items.
System The System menu is used to set-up system
parameters, set the clock, restart the
program and exit to the DOS operating
system.
Devices The dilution unit, ozone generator and the
optional perm oven and photometer are
covered under the Devices topic.
Options, parameters, and calibration
routines are provided for these devices.
Comm The Communications topic is used to
configure the serial communications ports
for remote terminal communications or
command mode operation.
Status The Status option is used to display status
information for the system when it is idle
or while calibration routines are running.
Diag System diagnostic routines are made
available by the Diag menu option.
Using the 2010D Screens
Most menu selections result in a screen being activated.
Several types of screens may be displayed while operating the
2010D:
Error Popup If an error occurs while operating the 2010D, an
Error Popup containing the error message will be
displayed. The Error Popup will prevent any other
actions until it is acknowledged by pressing the
Enter button.
To Next Page
Loading...
