Installation Page 4-
In addition to the physical wiring connections, the analog
output parameters must be set up for the specific application.
The 2010D allows the scaling and averaging of each analog output
to be independently set from the Photometer Parameters screen,
as described beginning on Page 9-12.
Instrument Solenoid Connections
If the Instrument Solenoid option is installed, external
solenoid valves may be attached to connector J10 and
automatically activated when an associated calibration Sequence
or Point is active. J10 is located on the option module's rear
panel (see Figure 4-1), which may also support other connectors
related to the Photometer or Permeation Oven, depending upon
what options are installed.
Table 4-12 Instrument Solenoid Connections
2010D J10 SIGNAL SIGNATURE
_______ _________________
J10-1 CHASSIS GROUND
J10-2 INSTRUMENT SOLENOID 1
J10-3 INSTRUMENT SOLENOID 2
J10-4 INSTRUMENT SOLENOID 3
J10-5 INSTRUMENT SOLENOID 4
J10-6 INSTRUMENT SOLENOID 5
J10-7 INSTRUMENT SOLENOID 6
J10-8
J10-9 CHASSIS GROUND
J10-10 GROUND
J10-11 GROUND
J10-12 GROUND
J10-13 GROUND
J10-14 GROUND
J10-15 GROUND
To Next Page
Loading...
