SAGEMCOM F@ST 2804v2 - Routing; Default Gateway

5 - Information / Configuration
F@st™ 2804v2 Reference Manual - 253329475-A
Page 5-98 Sagemcom document. Reproduction and disclosure prohibited
5.9.5 Routing
This menu contains 3 sub-menus:
• Default Gateway (see subsection 5.9.5.1),
• Static Route (see subsection 5.9.5.2),
• RIP (see subsection 5.9.5.3).
5.9.5.1 Default Gateway
Object: This menu is used either to allocate dynamically a default gateway address to the
router from a PVC or to enter an address or choose an interface.
• Select the Default Gateway sub-menu in the Routing menu in the Advanced Setup
section to display the following screen:
Field Action Default
EnableAutomatic Assigned
Default Gateway
Check the box to allocate automatically a
default gateway for your router.
Box checked
Use Default Gateway IP
Address
11
Check the box to use a default address.
Box checked
Not empty
Use Interface
11
Select the interface you want to use from
the scroll down list (pppoe_8_35_1 for
example).
Box
not checked
Interface
used
11
this field only appears when the "Enable Automatic Assigned Default Gateway" field is deactivated (box not
checked).