SAGEMCOM F@ST 2804v2 User Manual

5 - Information / Configuration
F@st™ 2804v2 Reference Manual - 253329475-A
Page 5-2 Sagemcom document. Reproduction and disclosure prohibited
5.1 Accessing the welcome screen
To access this screen, you must have configured one of your computer's interfaces
using the installation CD-ROM provided with your router:
• F@st
TM
2804v2 see chapter 3.
If you are using your computer's Ethernet card to configure your router, connect it to an Ethernet
port (ETH1 to ETH4)).
Your router is then configured using a simple Web browser (e.g. Internet Explorer).
The router's DHCP server function is activated by default with an address range
defined as indicated in subsection.5.9.2.
To access the configurer, proceed as follows:
1
In the Start menu, select All Programs / F@st 2804v2, then left click on
.
2
The following screen asks you to connect.
Enter admin by default in the "Username" field.
Enter admin by default in the "Password" field.
Then click on OK to confirm.
Note: The equipment's IP address (192.168.1.1) appears in the bar at the top of the
screen.

SAGEMCOM F@ST 2804v2 Specifications

General

Brand	SAGEMCOM
Model	F@ST 2804v2
Category	Network Router
Language	English