SAGEMCOM F@ST 2804v2 - 3 Installing and Configuring the F@St

232 pages

Save Page as PDF

To Next Page

To Previous Page

F@st™ 2804v2 Reference Manual - 253329475-A

Sagemcom document. Reproduction and disclosure prohibited Page 3-1

3. Installing and configuring the F@st™ 2804v2

router

Main Page

Default Chapter3
- Guide to Symbols Used in this Manual3
- How Should the Document be Used4
- Table of Contents5
List of Figures9
1 Introduction11
- Presentation12
- Composition of Router Pack14
- Minimum) Prerequisites15
2 Description and Connection of Your Router17
- Description18
  - Connectors19
  - Leds20
- Connecting the Ports of Your Router21
- Installing Your F@St22
- Installation Instructions27
3 Installing and Configuring the F@St29
4 Configuration of Network Parameters31
5 Information / Configuration37
- Accessing the Welcome Screen38
- Recommendations40
- ADSL Connection Status41
- Display Frame41
- Status42
  - Diagnostics43
- Internet Connection45
- Wireless46
- Nat78
- Advanced Setup88
- Advanced Status156
- Management166
6 Internet Access Service191
7 TV over ADSL Service193
- Introduction194
- Access to the Optional TV over ADSL Service194
8 Updating the Firmware195
- A. Annex a - Troubleshooting197
Annex a - Troubleshooting198
Checking the Assignment of an IP Address198
Front Panel Leds199
Supervising Your Router200
Diagnostics" Tool201
- A.4 "Diagnostics" Tool201
Interpreting the Leds203
- The "ADSL" LED Blinks Slowly203
- Wi-Fi" LED off203
- All Leds Are off203
Restarting Your Router204
Returning to the Factory Configuration204
Offline Mode205
- A.8 Offline Mode205
Annex B - Warnings for Safety207
Warnings for Safety208
- Safety Levels in Relation to the Case208
EC Compliance Declaration208
Annex C - Environment209
Directive E 2002/96/CE210
- C.1 Directive E 2002/96/CE210
- D. Annex D - Technical Characteristics211
Annex D - Technical Characteristics212
Mechanics; Display212
- D.1 Mechanics; Display212
Characteristics of the Different Interfaces213
Environmental Characteristics216
Application and Protocols217
Annex E - Default Configuration219
Default Username and Password220
Default Configuration for the Local Network (LAN220
Default Configuration for the Local Wireless Network (WLAN221
Annex F - Glossary223
Annex G - Connector Technology227
Pinouts of the " ADSL" Connector228
Pinouts of the "PWR" Connector228
Pinouts of the "ETH1", "ETH2", "ETH3" and "ETH4" Connectors229
Pinouts of the "USB" Connector230

SAGEMCOM F@ST 2804v2 - 3 Installing and Configuring the F@St

Table of Contents

Related product manuals