Annex A - Troubleshooting
F@st™ 2804v2 Reference Manual - 253329475-A
Page A-2 Sagemcom document. Reproduction and disclosure prohibited
A.1 Checking the assignment of an IP address
In Windows Vista, XP, 2000 and ME
¾ Click button Start, select Execute, enter cmd and then click OK; the command prompt
screen appears. Enter ipconfig and then confirm by pressing Enter.
¾ Check that the entry IP Address contains a value other than 0.0.0.0 (192.168.1.10 for
example).
If no address is displayed on the screen, enter ipconfig /release
followed by ipconfig /renew.
All the troubleshooting procedures described below are undertaken in
Windows® XP. These procedures in other Windows operating systems® (98, ME
and 2000) can be slightly different.
To help locate the fault, the user has the following sources:
¾ States of Front panel LEDs,
¾ Data accessible by the configurator by "DSL Router" onboard HTTP of your router:
• supervision of the router,
• "Diagnostics" tool.
To Next Page
Loading...
