142 • Program Maintenance SAM4s SPS-2000 Operator Manual v1.18
4. Touch the page #2 tab to set the remaining employee file options.
TRAINING MODE?
If Y, this employee will be in training, regardless of the training mode status of the entire register.
DEFAULT PRICE LEVEL
If multiple price levels are used, set the default level for this employee.
DEFAULT SCREEN LEVEL (0-200)
You can set a default screen level (keylink) to display when this employee is signed on to operate.
MANAGER
You can assign this employee “manager” status to perform manager controlled functions without
password entry.
EDIT JOB CODES
Note: An employee with the appropriate authority level must be signed on to perform job code
programming.
Job codes are used to break down the hours worked for all employees into different categories (See
"Labor Groups" report in the Operation Manual.) A breakdown of hours by job is also reported for each
employee (See "Time Keeping" reports in the Operation Manual.)
The job codes to be used by all employees are set up here. There are 20 possible job codes. Each job
code you wish to activate must be given a descriptor here.
EDIT PAY RATES
Note: An employee with the appropriate authority level must be signed on to perform pay rate
programming.
The pay rates set here can be used by all employees. There are up to 50 pay rates.
DALLAS KEY LINK
This option is not available.
To Next Page
Loading...
Need help?
General
