SAM4s SPS-2000 Operator Manual v1.18 Getting Started • 19
Screen Saver
A screen saver can be implemented; your authorized dealer can install a custom graphic
image to display. Depending upon the setting, the screen saver will display after 1 to 99
minutes of inactivity.
When the screen saver is activated, simply touch the screen to restore the normal display.
Initialize/Re-boot
The initialize function allows you to exit any register activity and return to a beginning or
cleared state. Any transaction that is in progress will be exited and totals for that transaction
will not be updated.
Here are some reasons you may want to initialize your ECR:
• The register is in an unknown state, and you wish to exit the current program or
transaction without following normal procedures.
• You have performed a function that includes a compulsory activity, such as
validating or printing, and you wish to bypass the compulsory activity.
• An initial clear may be necessary as part of servicing, or troubleshooting an SPS-
2000 register or system.
Perform this procedure only as necessary. Contact your authorized SAM4S dealer first if you
have questions about operating or programming your SPS-2000.
To Initialize the SPS-2000, turn the main power switch off, then on again. The SPS-2000
will be ready for operation about 30 seconds after re-booting.
Warning: If you initialize while a transaction is in progress, the transaction will be
aborted and totals/counters will not be updated.
To Next Page
Loading...
Need help?
General
