SAM4s SPS-2000 Operator Manual v1.18 Getting Started • 29
Error Messages
The SPS-2000 displays messages on the top line of the screen, immediately to the right of the function tabs.
Note that each of the standard messages described below can be customized. Your program may display
slightly different text messages.
AMOUNT REQUIRED
This operation requires an amount entry.
BAD VALUE
The number entered is incorrect for the task being performed.
BUFFER FULL
The buffer for soft check, hard check, or buffered receipt has reached capacity. For hard checks, the
operator must touch the SERVICE key to print the items and clear the buffer. The operator must then
pick up the previous balance again in order to continue with finalization. In a soft check environment,
this message will appear when the check has reached capacity (maximum lines stored). The register will
require the sale to be finalized with the option of printing a bill if required
BUSY
Destination register is busy (pre poll memory is in use). Requires a clear command from the P.C. or
Register.
CASH DECLARATION REQUIRED
Cash declaration has been programmed as compulsory, and must first be performed before reports
CASH-IN-DRAWER LIMIT EXCEEDED
The programmed Cash-In-Drawer limit has been exceeded.
CHECK KEY POSITION
The key lock is in the wrong position.
CHECK# IS ASSIGNED AUTOMATICALLY
The operator has attempted to open a new guest check by assigning a check number. The register has
been programmed to generate its own check numbers.
CHECK# REQUIRED!
This register has been programmed to force check number entry to begin a transaction. An existing guest
check must be recalled, or a new one started.
CONDIMENT REQUIRED!
This PLU has been programmed to require a condiment entry.
CRC ERROR
An error has occurred in the block check sum while transferring data in IRC mode.
DUPLICATE!
This check already exists. May also apply to secret code programming.
ANALYSIS 1?/ANALYSIS 2?/ANALYSIS 3?
This operation is set for compulsory entry of one of the three analysis keys.
To Next Page
Loading...
Need help?
General
