Sam4s SPS-2000 - Registering a Not Found PLU

42 • Basic Operations SAM4s SPS-2000 Operator Manual v1.18
Registering a Not Found PLU
Designed to be used in a scanning system, the NOT FOUND PLU key allows the operator to
immediately enter basic PLU information for an item that is not in the PLU file. If the "Not
Found PLU" message displays when a PLU is entered (or when an item is scanned) the
operator can touch the NOT FOUND PLU key and will be prompted to enter PLU price, and
if programmed, the descriptor and linking information. The item is registered immediately.
1. Scan or enter a PLU that is not in the PLU file. The NOT FOUND PLU message
displays.
2. Touch the NOT FOUND PLU key. The PRICE/HALO entry box displays.
3. Enter the price for the item, touch OK. The LINK STATUS entry box displays.
4. Enter the status link for the PLU, touch OK. The LINK GROUP entry box displays.
5. Enter the primary group link for the PLU, touch OK. The DESCRIPTOR entry box
displays.
6. Use the alpha keyboard overlay to type the descriptor for the item, touch OK. The
item is registered.