Sam4s SPS-2000 - Split Check-Graphical Method

82 • Basic Operations SAM4s SPS-2000 Operator Manual v1.18
Split Check—Graphical Method
Graphical split check is available at software version 3.00j or later. This feature is available
for systems using check tracking (Not table tracking—if table tracking is required use check
number representing the table number) and manually input check numbers (see “
Checks
Assigned by Register Notes” on page
85.)
Use the Split Check function key (Key #249) to select item or items on a soft check for
assignment to another check. To split items from one check to another:
1. Open a new check and add items, or open an existing guest check.
2. Touch Split Check. The Split Check Edit screen displays with the current check
items listed. Note that if you are consolidating like items (for example “2 BUD”) and
you wish to split one of the items, you must first use the split item key to separate the
items (“1 BUD” and “1 BUD”).
Note: Optionally, you can touch the number of new checks you wish to split, and
then touch the Split Check function key, you will be immediately prompted to enter
the new check numbers and then the Split Check Edit screen will open with the next
checks available to move items.
Left Arrow and
Right Arrow keys
are active only
when you are
separating into
more than three
checks. When
four or more
checks are open,
use these keys to
view the check
where you wish to
move items.