Sam4s SPS-2000 - Print Key

44 • Basic Operations SAM4s SPS-2000 Operator Manual v1.18
Auto Tare Weight
1. Place the item on the scale.
2. Touch the SCALE key to display the weight.
3. Register the open or preset PLU.
Manual Tare Weight Entry
1. Place the item on the scale.
2. Enter the tare # and touch the SCALE key to display the weight less the tare.
3. Register the open or preset PLU.
Open Tare Weight Entry
1. Place the item on the scale.
2. Touch 20. This will call for tare 20, which is an open tare.
3. Touch the SCALE
4. Touch the decimal [.], then the numeric 3. This will enter a tare weight of 0.3 lb.
5. Touch the SCALE key.
6. Register the open or preset PLU.
Print Key
The PRINT key allows the operator to send items to the kitchen printer. Use the PRINT key
(or label the key GRILL) to send items wouldn't normally go to a kitchen printer or send
items that require special attention. All printer output made using the key is in addition to
regular output.
To use the PRINT key function, touch the PRINT key before the first item and immediately
after the last item to want printed for special attention.
1. Touch PRINT.
2. Enter the item and condiments or instructions.
3. Touch the PRINT key again to send the item & instructions to the printer identified
on the PRINT key.
Note: The PLU Status Group flag #28 “Print on KP?” must be set to Y (yes) for items
that are to be sent to a printer via the PRINT key.
The PRINT key also sends items in group sequence using the “meal order feature” available
at version 2.02n or later. Items are given a meal order priority through group programming.
Each time the PRINT key is touched, the next priority of items will be release to the kitchen
printer.