Sam4s SPS-2000 - Adding to a Check

74 • Basic Operations SAM4s SPS-2000 Operator Manual v1.18
Adding to a Check
1. If a table and check are both assigned you may either:
• Enter the check number, touch the appropriate recall check function, i.e. RECALL
#1
• Enter the table number, touch the appropriate Table # function, i.e. TABLE 1.
2. If you open a table where more than one check is open, the screen will list the open
checks for the table:
3. Touch a check to select it and then touch OPEN.
A dotted line
displays to separate
items posted
previously from
items posted at this
time.