SAM4s SPS-2000 Operator Manual v1.18 Basic Operations • 73
Beginning a Check
1. Depending on how your system is programming, you can begin a check with either a
check or table:
• Enter check number: depending upon programming you may enter the check number
and touch one of the Recall Check functions, i.e. RECALL #1, or touch the
RECALL key to automatically assign a check number. (After beginning a check
with the check number, you may be required to enter a table number, or if table enter
is not required, you may optionally enter a table number.)
• If Table# is compulsory, if only one check per table is allowed, and if checks are
automatically assigned, you can enter the number of the table and touch TABLE#.
The table is opened and the check is automatically assigned.
2. If guest entry is required, enter number of guests and touch the GUEST # key.
3. Enter the items ordered.
4. Touch the appropriate Store Check function, i.e. STORE #1. The message “SERVED”
displays momentarily.
The check #, table #,
guest count and
employee associated
with the check are
dis
la
ed.
To Next Page
Loading...
Need help?
General
