Samsung Electronics 365
Piping Diagram
Electronic Expansion Valve(EEV) Control
▪ Purpose
General control: Maintain the amount of refrigerant flowing into the indoor units at the appropriate level.
Inactive indoor unit control: Prevent insufficient refrigerant due to refrigerant stagnating in the piping connected to inac-
tive indoor units.
▪ Concept
General control: Control is performed with the superheat degree in cooling mode. In heating mode, control is performed
with the subcooling degree.
Inactive indoor unit control: The gas pipe is kept open slightly in heating mode to prevent refrigerant from stagnating in
the piping.
▪ Control specifications in detail
∙ Condition(s) required to use modes
- General control : Thermos on indoor units are on
- Inactive indoor unit EEV control: (Comp OFF) or (Comp ON and Indoor unit Thermo-OFF)
∙ Operation specifications
- General control: Control is performed with the superheat degree at the exit of indoor heat exchanges in cooling mode.
In heating mode, control is performed with the subcooling degree.
- Inactive indoor unit EEV control: Control is performed as shown in the following table.
Outdoor unit operation COMP ON COMP OFF
Indoor unit operation Cooling Heating
COMP stops
- 3 min
COMP stops
3 - 5 min
COMP stops
5 min elapses
(Auto) cooling /
Dehumidification /
Fan
Thermo On Cooling EEV control 0 0 35
Thermo Off 0 Note 1* 0 0 35
(Auto) heating
Operation On Heating EEV control 35 35 35
Operation Off 0 Note 1* 35 35 35
* Note 1 : Control of inactive heating units (lower noise/general)
Outdoor unit for first priority
outdoor unit
CAM EDM high-head EDM general
0℃ or lower 80 130 200
Above 0℃ 80 120 180
Cooling
Condensed liquid
Gas
Hot gas
Condensed liquid
Heating
7-3 Functions (cont.)
7-3-2-6 Indoor unit control (cont.)
7-3-2 Control (cont.)
To Next Page
Loading...
