S&C TripSaver II - Page 34

34 S&C Instruction Sheet 461-509
The second section in the XML file format is encapsulated by <DNP3> tags. This
contains more structured information such as the list of binary input setpoint mappings,
for example:
<DNP3>
<BinaryInputSetPoints>
<binaryinputsetpoint statuspoint=”0” codedescription=”1” eventclass=”2”/>
<binaryinputsetpoint statuspoint=”3” codedescription=”2” eventclass=”1”/>
</BinaryInputSetPoints>
</DNP3>
The configuration settings that can be specified in this section of the document are
described in Table 2.
Table 2. Import and Export Settings Configuration
Parameter Group Attribute Description
Data
Type
Range of Value
<DNP3Masters>
<dnp3master/>
</DNP3Masters>
unsolicitedenabled
Boolean indicating whether the gateway will attempt to send
DNP3 unsolicited responses to the SCADA master. See
Unsolicited Response on DNP3 Master Settings screen.
Boolean True or False
port
Gateway’s TCP or UDP listen port for receiving IP packets
from the SCADA master.
Integer 1024 … 49,151
ipaddress
SCADA master’s IP address. Currently ignored by the gateway
as it will accept traffic from any IP address. See IPv4 Address
on DNP3 Master Settings screen.
IP
address
(dotted
decimal)
Any valid IP
address
dnp3address
SCADA master’s DNP3 address. See DNP3 Address on
DNP3 Master Settings screen.
Integer 1 … 65,519
<BinaryInputSetPoints>
<binaryinputsetpoint/>
</BinaryInputSetPoints>
statuspoint See Status Point on DNP3 Outstation Settings screen. Integer 0 … 147
codedescription See Code Description on DNP3 Outstation Settings screen. Integer
Per S&C
Instruction Sheet
461-560
eventclass
See Class on DNP3 Outstation Settings screen A value of 0
corresponds to NO EVENT.
Integer 0,1,2,3
Conguring the Communications Gateway
TABLE CONTINUED▶