Sanyo PLC-XU301A - Filter Cleaning and Reset

60
Maintenance and Cleaning
Turn off the projector, and unplug theAC power cord
fromtheACoutlet.
Turntheprojectoroverandremovethefilters.
1
2
Filterpreventsdustfromaccumulatingontheopticalelementsinsidetheprojector.Shouldthefiltersbecome
cloggedwithdustparticles,itwillreducecoolingfans’effectivenessandmayresultininternalheatbuildup
andadverselyaffectthelifeoftheprojector.Ifa“Filterwarning”iconappearsonthescreen,cleanthefilters
immediately.Cleanthefiltersbyfollowingthestepsbelow.
Cleanthefilterssoftlybyusingabrush.
3
Replacethefiltersproperly.Makesurethatthefilters
arefullyinsertedtotheprojector.
4
CAUTION
Donotoperatetheprojectorwiththefilters
removed.Dustmayaccumulateontheoptical
elementsdegradingpicturequality.
Donotputanythingintotheairvents.Doingso
mayresultinmalfunctionoftheprojector.
RECOMMENDATION
We recommend avoiding dusty/smoky environments
when you operate the projector. Usage in these
environments may cause poor image quality.
 Whenusingtheprojectorunderdustyorsmokyconditions,
dustmayaccumulateonalens,LCDpanels,oroptical
elementsinsidetheprojectordegradingthequalityofa
projectedimage.Whenthesymptomsabovearenoticed,
contactyourauthorizeddealerorservicestationforproper
cleaning.
Note:
 Whenreinsertingthis
filter,besurethatthe
slitpartisfacingthe
outerside.
BesuretoresettheFiltercounteraftercleaningorreplacing
thefilters.
PresstheMENUbuttontodisplaytheOn-Screen
Menu.UsethePoint▲▼buttonstoselecttheSetting
andthenpressthePoint►orSELECTbuttons.
UsethePoint▲▼buttonsselectFilter counterand
thenpressthePoint►orSELECTbutton.Usethe
Point▲▼buttonstoselectFilter counter resetand
thenpressSELECTbutton.TheFilter counter Reset?
appears.SelectYestocontinue.
1
2
Resetting the Filter Counter
Filter counter
TheFilter counter
Reset? appears.
SelectYes,then
anotherconfirmation
boxappears.
SelectYesagain
toresettheFilter
counter.
Anotherconfirmationdialogboxappears,selectYesto
resettheFiltercounter.
3
Filters.
Cleaning the Filters