SATO CL408 - Page 122

122 SATO RISC Printers
3. Command Code Quick Reference Programming Manual
C Repeat Label. Prints a duplicate of the last label prin-
ted.
CSa Print Speed Selection. Specifies a unique print speed
in in./sec. through software for a particular label.
Dabbcccd Bar Codes. Prints 1:2 ratio bar code. For UPC and
EAN bar codes, this will add descender bars. For
values a, bb, ccc and d see instructions for Babbcccd.
DCxx...x Data Matrix. Print Data. Prints data using Data Matrix
format specified in BX Data Format command.
xx...x = Data to be printed. Cannot exceed 500 cha-
racters.
Eaaa Line Feed. Provides the ability to print multiple lines of
the same character size without specifying a new print
position for each line.
aaa = Number of dots (1-999) between the bottom
of the characters on one line to the top of the
characters on thenext line.
Faaaabcccc
ddee Sequential Numbering. Allows the printing of sequen-
cing fields (text, bar codes) where all incrementing is
done within the printer.
aaaa = Number of times to repeat the same data
(0001-9999)
b = Plus or minus symbol (+ for increments; - for
decrements)
cccc = Value of step for sequence (001-9999)
dd = No. of digits for sequential numbering (01-99,
default = 8)
ee = No. of digits free from sequential numbering
(01-99, default = 0)
FWaaHbbbb Horizontal Line. Prints a horizontal line. Units of mea-
surement are dots.
FWaabbVccc
Hdddd Box. Prints a box. For values aa, bbbb, cc, and dddd,
see instructions for horizontal and vertical lines. Units
of measurement are dots.
FWccVddd Vertical Line. Prints a vertical line. Units of measure-
ment are dots.