SCANMATE ERROR REPORT
Edition 1 • January 1996 Service Manual • ScanMate 4000/5000
1•13
ScanMate software version: _____________ Calibrated when cold ______________
System Configuration: ___________________________________________________________
Hardware problem: Mechanical ___ Controller ____ Power supply _____ PMT ____
_______
Sensor unit ______ Light source ______ Communication _______ Other ______
Action taken to correct error:
White calibration succeeded? _____ If no, please attach calibration log with this report
Equipment exchanged to correct error? ______ What was changed _______________
__________________ Checked for loose cables? _______ Adjusted focus? ________
Adjusted light transmision? _______ Adjusted PMT? _______
Description of the error:
(If scanning is possible, please supply an RGB image indicating the problem - preferably on diskette)
(This block for ScanView use)
Description:
Warranty ___ Warranty exchange ____ Service _____ Service exchange _____
CRN ____________
ScanView dealer: ______________________________________________________________
Contact person: ________________________________ Date: _____________________
ScanMate Ser. nr. ____________ Hardware problem? ____ Software problem? ______
Spare part nr. __________________ Module Ser. nr. _______________ SIF nr. ______
To Next Page
Loading...