3 • SERVICE PROGRAM
Edition 1 • January 1996 Service Manual • ScanMate 4000/5000
3•9
Aperture point found.
5 First, Second, Diff : 208.000000, 78.000000, 2.666667
It is programmed, with return code 0.
Apertures found ok.
The spindle is started.
Toggle lamps (0)
This command faclility is used to toggle the lamps.
Select 0 to enter the toggle lamps menu and the following will be
shown:
>> Transmission lamp is set ON
Select 0 again and the following will be shown:
>> Reflection lamp is set ON
Select 0 again and the following will be shown:
>> Lamps are set OFF
Turn on SCSI (S)
This command faclility is used to turn on the SCSI interface and when
activated, the scanner can be controlled from and scan into, the Mac or
PC through the interface.
When the command is executed, the only way to return to the monitor
program mode is to turn the scanner off and then on again.
Select S to enter the Turn on SCSI menu and the following will be shown:
>> The ScanScsi routine is called now
Status received : HBCR-161 Version 15
Found barcode chip
The scanner is now in the SCSI mode. To return to the service mode
and main menu, turn the scanner off and then on again.
Turn on SCSI in switch seek mode (W)
This command faclility is used only for adjusting the position of the
zero switch.
Select W to enter the Turn on SCSI in switch seek mode menu and the
To Next Page
Loading...