SCANVIEW ScanMate 5000 - Rotate drum (T); Set focus position to zero (H); Test barcode circuit (G)

Service Manual • ScanMate 4000/5000 Edition 1 • January 1996
3•10
3 • SERVICE PROGRAM
following will be shown:
>> The ScanScsi routine is called now
Status received : HBCR-161X Version 15
Found barcode chip
The scanner is now in the SCSI mode. To return to the service mode
and main menu, turn the scanner off and then on again.
Rotate drum (T)
This command faclility is used to start the drum rotating.
Select T to enter the Rotate drum menu and the following will be
shown:
>> Enter wanted drum speed in rpm.
Drum speed set to xxxx RPM
Press Enter.
To stop the drum after the drum speed has been entered, select T, then
0 and enter.
Set focus position to zero (H)
This command facility is used to set the focus position to zero.
Select H to enter the Set focus position to zero menu and the following
will be shown:
>> Now we set the focus position to zero
Seeking focus switch
Focus zero point found
Test barcode circuit (G)
This command facility is used to test the barcode reader.
Select D to enter the Test the barcoded circuit menu and the following
will be shown:
>> Switching to barcode chip