SCANVIEW ScanMate 5000 - Choose aperture (4); Check focus (7)

To Next Page

To Previous Page

3 • SERVICE PROGRAM

Edition 1 • January 1996 Service Manual • ScanMate 4000/5000

3•7

Choose aperture (4)

This command facility is used to choose the aperture required.

Select 4 to enter the Choose Aperture menu and the following will be

shown:

>> Which aperture should be selected <0-6)

Searching for aperture x

Aperture point found

Aperture x found

Note: choose aperture 1 for all adjustments

Check focus (7)

This command facility is used to check the focus value.

Select 7 to enter the Check focus menu and the following will be shown:

>> Is it for transmission or reflection <T/R>: Now we check

the focus position.

In both sub-menus, T (transmission) and R (reflection) selection para-

meters are the same, therefore only T will be shown below.

Select T to enter the transmission menu and the following sub-menu

will be shown:

Now we check the focus position

Use BarCode or Index values : <B/I>:

Select B to enter the barcode sub-menu and the following will be

shown:

Status received : HBCR-161X Version 15

Found BarCode chip