3 • SERVICE PROGRAM
Edition 1 • January 1996 Service Manual • ScanMate 4000/5000
3•5
To view the log file, press F10 to exit the monitor program and use an
ASCII editor (for instance EDIT) to examine the log file after a session.
Using the monitor program.
The protocol is 9600 baud, 8 data bits, 1 stop bit, and no parity.
Use a Mac or PC cable (depending on your equipment), which are supp-
lied in the service kit.
Terminate the SCSI connector and check that the dip switch is set, for
example to number 8 (SCSI address 3).
Note: DO NOT connect or disconnect SCSI with power on.
Start the Mac or the PC in communication mode and turn on the scanner.
If you will start your PC monitor program from a disk, type:
Scanmate /5000.
To choose the com port, type:
ScanMate /5000 /2 (com 2)
The following will now scroll over the screen:
Hello World
Motherboard number is: xxx
Focus point 0: xxxx
My ID is X
Prom version is x.xx
ScanMate 5000 monitor version x.xx
Commands available are :
Move spindle Z/P/L/. 1
Adjust PMT gain 2
Choose aperture 4
Check focus 7
Calibrate apertures 9
Toggle lamps 0
Turn on SCSI S
Turn on SCSI in switch seek mode W
Rotate drum T
Set focus position to zero H
Test barcode circuit G
Show scanner options *
Show this help menu ?
F3) Enable/disable LOGFILE
F10)Exit monitor program
To Next Page
Loading...